Mixing principle - 1:3 with water (5 ml ampoule: 15 ml water)

How to use FGZ Professional Dr. Therapy SOS Instant Reconstructor?

Method #1 - With an ultrasonic hair straightener

1. Rinse your hair twice with a deep cleansing shampoo without leaving any foam on your hair.
2. Blow dry your hair by 50%.
3. Divide the hair into 4 sectors. Apply the composition from the back of the head, allowing for excess.
4. During the entire procedure, use a brush and comb with thin teeth to distribute the composition along the entire length.
5. Keep the composition for 10 minutes.
6. Treat strands 1.5-2 cm thick with an ultrasonic straightener up to 6 times. Do not touch the plates of the strand straightener, leaving a small gap between them for the ultrasound to work. Or leave the composition for 20 minutes without using the ultrasonic straightener.
7. Rinse off the composition by 50% without using shampoo.
8. Dry your hair 100% with warm air from a hair dryer using a round comb.
9. Divide the hair into 4 sectors. Heat at a temperature of up to 170 degrees, working through each strand 5 times along the entire length.

The procedure is complete!

Method #2 - With a thermal cap

1. Wash your hair twice with a deep cleansing shampoo according to your hair type. IMPORTANT! Do not comb your hair, as this closes the scales, which impairs the penetration of the composition deep into the hair.
2. Pat your hair dry with a towel to remove excess moisture.
3. Mix Botox with water (15 ml of water per 5 ml of Botox) or with a mask.
4. Apply the composition to the hair in a straight line, avoiding excess IMPORTANT!!! Do not apply the composition to the scalp, retreat 1 cm from the roots and do not oversaturate with the composition.
5. Keep the composition for up to 30 minutes under a cap.
6. Rinse off the composition within a minute so that the roots are clean and the composition is not felt along the entire length.
7. Blow-dry your hair and style it as desired.